Оранжевый/Фиолетовый (-) See NOTE #4 Requires Part #775 Relay
Водительская кик панель
Раздвижная дверь
Н/Д
Сигнал
DARK Зеленый/Оранжевый (+)
СигналилиIPM,Разъем, C2 pin 35, See NOTE #5
Тахометр
Любой кроме Красный/TANилиDARK Зеленый/Светлозеленый
Форсункииликатушка зажигания
WAIT TO START LIGHT
Н/Д
Тормоз
Белый/TAN (+)илиБелый/Светлозеленый (+)
Педаль тормоза
Отключение штатной сигнализации
Н/Д
ANTI-THEFT
CHRYSLER’S MULTIPLEX Зажигание/TRANSPONDER SYSTEM, SEE NOTE #1
NOTES
NOTE #1: This vehicle requires a speciall INFERFACE BYPASS MODULE for REMOTE STARTING Цепь # DB-ALLилиXK09 BYPASS MODULE, to order either module go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: vehicles with MEMORY SEATS, have to go to the DRIVERS MEMORY MIRRO MODULE in the door to get this wire. The LOCK wire requires a (-)Negative thru 330 Ohm resistorиUNLOCK requires a (-)Negative thru a 100 Ohm resistor, some units require 2 extra relays part #775, to connect. See Дополнительно
NOTE #3: the Водительская дверь is a Фиолетовый (-) PIN 6, the PASSENGER DOOR is a Фиолетовый/Белый (-) PIN 7, the DRIVERS REAR DOOR is a Фиолетовый/Серый (-) PIN 4,иthe PASSENGER REAR DOOR is a Фиолетовый/Желтый (-) PIN 5, when connecting an ALARM SYSTEM, use all 4 Двери wiresиDIODE ISOLATE, to connect, See Дополнительно.
NOTE #4: when testing the TRUNK/HATCH RELEASE wire, you must use the Key to open the REAR GLASS, this wire should then show a (-) Negative during testing.
NOTE *1 Use Оранжевый/VIOLET for LOCKиРозовый/Черный for UNLOCK at the Водительская дверь SWITCH. Use Черный/Белый for LOCKиРозовый/Черный for UNLOCK at the passenger front door switch. This vehicle requires (2) of part # 778 one for each door See Дополнительно. TO AVOID INSTALLING RELAYS IN BOTH DOORS. USE INTERFACE MODULE Part # XK09илиDB-ALL. These are combo modules that bypass the Anti-theftиenable the use of keyless entry without adding relays. To make a keyless entry system work you can create the circuit above using (2) #778 realys but it’s recommended to use the XK09илиDB-ALL.
NOTE *2 the Желтый Parking light wire will require a (-) Negative thru a 1300 Ohm resistorиa extra relay part #775, to connect, See Дополнительно.
NOTE *3 this vehicle has 4 Двери input wires, the Водительская дверь is a TAN/Красный (-) at the Водительская дверь LOCK SWITCH, the PASSENGER DOOR is a TAN/Красный (-) at the PASSENGER DOOR LOCK SWITCH, the DRIVERS REAR DOOR is a TAN/Оранжевый (-)иthe PASSENGER REAR DOOR is a TAN/Желтый (-) both are at the BCM (Body Control Module), when connecting to an ALARM SYSTEM you must BOTH Двери wiresиDIODE ISOLATE, to connect, See Дополнительно
NOTE *4 on the 4.7L engine, go to any coilиuse any wire that is NOT DARK Зеленый/Оранжевый. On the 4.0L engine, use any wire with a TAN STRIPE at the coil pack
NOTE *5 to DISARM the FACTORY ALARM SYSTREM requires a (-) NEGATIVE thru a 463 Ohm Resistorиan extra relay part #775, to connect, See Дополнительно
Точки подключения автосигнализаций