B1024 ошибка nissan juke

B1024 ошибка nissan juke

DTC CONFIRMATION PROCEDURE

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSTIC RESULT

1. Turn ignition switch ON.

2. Perform �Self Diagnostic Result� mode of �AIR BAG� using CONSULT-III.

1. Turn ignition switch ON.

2. Check the air bag warning lamp status. Refer to SRC-12, «On Board Diagnosis Function».

:
SRS does not enter diagnosis mode if no malfunction is detected in user mode.

Is malfunctioning part detected? YES >> Refer to SRC-34, «Diagnosis Procedure».

Diagnosis Procedure

WARNING:
� Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes.

(To discharge backup capacitor.) � Never use unspecified tester or other measuring device.

Check the connection of harness connector.

Is the connection normal? YES >> GO TO 2.

NO >> Replace harness connector.

2.CHECK WIRING HARNESS

Check the wiring harness externals.

Are the harness external parts normal (no damage)? YES >> GO TO 3.

NO >> Replace wiring harness.

3.CHECK AIR BAG CUTOFF SWITCH

1. Replace air bag cutoff switch..

2. Perform DTC confirmation procedure. Refer to SRC-34, «DTC Logic».

Is DTC detected? YES >> GO TO 4.

4.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

1. Replace air bag diagnosis sensor unit. Refer to SR-30, «Removal and Installation».

2. Perform DTC confirmation procedure. Refer to SRC-34, «DTC Logic».

B1023 passenger air bag off indicator

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform �Self Diagnostic Result� mode of �AIR BAG� using CONSU .

B1026, B1027, B1028, B1029, B1030, B1031 diagnosis sensor unit

DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform �Self Diagnostic Result� mode of �AIR BAG� using CONSU .

Читайте также:  Задний опорный подшипник hyundai tucson
Other materials:

Diagnosis system (BCM)
Common item : consult-III Function (BCM — COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for .

P1550 battery current sensor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. .

Precaution
Precaution for Supplemental Restraint System (SRS) «AIR BAG» and «SEAT BELT PRE-TENSIONER» The Supplemental Restraint System such as �AIR BAG� and �SEAT BELT PRE-TENSIONER�, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver a .

Источник

Оцените статью
Adblock
detector