B1023 ошибка nissan juke
Nissan Juke Service and Repair Manual : B1023 passenger air bag off indicator
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
1. Turn ignition switch ON.
2. Perform �Self Diagnostic Result� mode of �AIR BAG� using CONSULT-III.
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, «On Board Diagnosis Function».
:
SRS does not enter the diagnosis mode if no malfunction is detected in the user mode.
Is malfunctioning part detected? YES >> Refer to SRC-32, «Diagnosis Procedure».
Diagnosis Procedure
WARNING:
� Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) � Never use unspecified tester or other measuring device.
1.CHECK HARNESS CONNECTOR
Check the connection of harness connector.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace harness connectors.
2.CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace wiring harness.
3.CHECK PASSENGER AIR BAG OFF INDICATOR
1. Replace passenger air bag OFF indicator.
2. Perform DTC confirmation procedure. Refer to SRC-32, «DTC Logic».
Is DTC detected? YES >> GO TO 4.
4.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
1. Replace air bag diagnosis sensor unit. Refer to SR-30, «Removal and Installation».
2. Perform DTC confirmation procedure. Refer to SRC-32, «DTC Logic».
Is DTC detected? YES >> GO TO 1.
B1011, B1012, B1013, B1014, B1015 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform �Self Diagnostic Result� mode of �AIR BAG� using CONSU .
B1024 pass A/B deact SW
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAGNOSTIC RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform �Self Diagnostic Result� mode of �AIR BAG� using .
Other materials:
B1186, B1187, B1188, B1189, B1190, B1191 diagnosis sensor unit
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform �Self Diagnostic Result� mode of �AIR BAG� using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu .
Precaution for Brake System
WARNING: Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with compressed air. � Brake fluid use refer to MA-13, «Fluids and Lubricants». � Never reuse drained brake fluid. � Never spill or splash brake fluid on painted surfaces. Brake flui .
Trouble diagnosis — specification value
Description The specification (SP) value indicates the tolerance of the value that is displayed in �SPEC� of �DATA MONITOR� mode of CONSULT-III during normal operation of the Engine Control System. When the value in �SPEC� of �DATA MONITOR� mode is within the SP value, the Engine Control Sys .