B0096 ошибка nissan qashqai

Qashqai J11. SRS Airbag control system — part 5

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

>> To check malfunction symptom before repair: Refer to

>> Confirmation after repair: INSPECTION END

INFOID:0000000010431037

• Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 min-

utes. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device.

Check the connection of harness connector.

>> Replace harness connector.

Check the wiring harness externals.

Are the harness external parts normal (no damage)?

CHECK AIR BAG CUTOFF SWITCH

Replace air bag cutoff switch. Refer to

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to

(Trouble diagnosis content)

PASS A/B DEACT SW
[Passenger Restraints Disable Switch (Sub-
fault)]

Air bag cutoff switch circuit is open or shorted to ground or the circuits
are shorted each other.

B00DF AIR BAG CUTOFF SWITCH

B0099 SATELLITE SENSOR

INFOID:0000000010377852

• Connection malfunction or short circuit to ground of harness and connector
• Internal malfunction of other satellite sensor
• Internal malfunction of air bag diagnosis sensor unit

[B0099–23, B0099–24, B0099–25, B0099–28

• Internal malfunction of other satellite sensor
• Internal malfunction of air bag diagnosis sensor unit

• Connection malfunction of harness or connector
• Internal malfunction of other satellite sensor
• Internal malfunction of air bag diagnosis sensor unit

• Air bag diagnosis sensor unit and other satellite sensor is different from the part specified

• Connection malfunction or open circuit of harness and connector
• Internal malfunction of other satellite sensor
• Internal malfunction of air bag diagnosis sensor unit

DTC CONFIRMATION PROCEDURE

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

INFOID:0000000010377853

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device.

Читайте также:  Крепление зеркала bmw x5 e53

(Trouble diagnosis content)

SATELLITE SENSOR
[Roll Over Sensor (Subfault)]

Other satellite sensor circuit is shorted to ground

Lower limit value malfunction of other satellite sensor

Upper limit value malfunction of other satellite sensor

Diagnosis malfunction of other satellite sensor

Offset malfunction of other satellite sensor

Communication malfunction of other satellite sensor

Other satellite sensor is out of the specified specification

Other satellite sensor circuit is open

Reset malfunction of other satellite sensor

B0099 SATELLITE SENSOR

Perform each inspection according to the displayed DTC.
Which DTC is displayed?

[B0099–86] >> GO TO 4.
Other than the above >> GO TO 2.

Check the harness connector.

Is the inspection result normal?

>> Replace harness connector.

Check the wiring harness externals.

Is the inspection result normal?

REPLACE OTHER SATELLITE SENSOR

Replace other satellite sensor. Refer to

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to

B1400, B1401, B1402, B1403, B1404, B1405 AIR BAG DIAGNOSIS SENSOR

B1400, B1401, B1402, B1403, B1404, B1405 AIR BAG DIAGNOSIS SEN-
SOR UNIT

INFOID:0000000010431056

Malfunction in air bag diagnosis sensor unit

DTC CONFIRMATION PROCEDURE

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

>> To check malfunction symptom before repair: Refer to

>> Confirmation after repair: INSPECTION END

INFOID:0000000010431057

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device.

Check the harness connector.

Is the inspection result normal?

>> Replace harness connectors.

Check the wiring harness externals.
Is the inspection result normal?

(Trouble diagnosis content)

CONTROL UNIT
(airbag control unit)

Air bag diagnosis sensor unit is malfunctioning

CONTROL UNIT
(airbag control unit internal trouble, sensor2)

CONTROL UNIT
(airbag control unit internal trouble, sensor3)

CONTROL UNIT
(airbag control unit internal trouble, sensor4)

CONTROL UNIT
(airbag control unit internal trouble, sensor5)

Читайте также:  P1217 ошибка nissan qashqai j10

CONTROL UNIT
(airbag control unit internal trouble, sensor6)

B1400, B1401, B1402, B1403, B1404, B1405 AIR BAG DIAGNOSIS SENSOR

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to

B1406, B1407, B1408, B1409, B1410 AIR BAG DIAGNOSIS SENSOR UNIT

B1406, B1407, B1408, B1409, B1410 AIR BAG DIAGNOSIS SENSOR UNIT

INFOID:0000000010431058

Malfunction in air bag diagnosis sensor unit

DTC CONFIRMATION PROCEDURE

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

>> To check malfunction symptom before repair: Refer to

>> Confirmation after repair: INSPECTION END

INFOID:0000000010431059

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device.

Check the harness connector.

Is the inspection result normal?

>> Replace harness connectors.

Check the wiring harness externals.
Is the inspection result normal?

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to

(Trouble diagnosis content)

CONTROL UNIT
(airbag control unit internal trouble, Energy
Reserver)

Air bag diagnosis sensor unit is malfunctioning

CONTROL UNIT
(airbag control unit internal trouble, driver IC1)

CONTROL UNIT
(airbag control unit internal trouble, driver IC2)

CONTROL UNIT
(airbag control unit internal trouble, driver IC3)

CONTROL UNIT
(airbag control unit internal trouble, Power IC)

B1406, B1407, B1408, B1409, B1410 AIR BAG DIAGNOSIS SENSOR UNIT

B1411, B1412, B1413, B1414, B1415 AIR BAG DIAGNOSIS SENSOR UNIT

B1411, B1412, B1413, B1414, B1415 AIR BAG DIAGNOSIS SENSOR UNIT

INFOID:0000000010431060

Malfunction in air bag diagnosis sensor unit

DTC CONFIRMATION PROCEDURE

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

>> To check malfunction symptom before repair: Refer to

>> Confirmation after repair: INSPECTION END

INFOID:0000000010431061

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device.

Читайте также:  Тренажер кроссовер айрон кинг

Check the harness connector.

Is the inspection result normal?

>> Replace harness connectors.

Check the wiring harness externals.
Is the inspection result normal?

(Trouble diagnosis content)

CONTROL UNIT
(airbag control unit internal trouble, SUB IC)

Air bag diagnosis sensor unit is malfunctioning

CONTROL UNIT
(airbag control unit internal trouble, communi-
cation IC1)

CONTROL UNIT
(airbag control unit internal trouble, communi-
cation IC2)

CONTROL UNIT
[airbag control unit internal trouble, Main mi-
cro controller (CPU)]

CONTROL UNIT
[airbag control unit internal trouble, Sub mi-
crocontroller (CPU)]

B1411, B1412, B1413, B1414, B1415 AIR BAG DIAGNOSIS SENSOR UNIT

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to

B1416, B1417, B1418, B1419, B1420 AIR BAG DIAGNOSIS SENSOR UNIT

B1416, B1417, B1418, B1419, B1420 AIR BAG DIAGNOSIS SENSOR UNIT

INFOID:0000000010431062

Malfunction in air bag diagnosis sensor unit

DTC CONFIRMATION PROCEDURE

Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

>> To check malfunction symptom before repair: Refer to

>> Confirmation after repair: INSPECTION END

INFOID:0000000010431063

• Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3

minutes or more. (To discharge backup capacitor.)

• Never use unspecified tester or other measuring device.

Check the harness connector.
Is the inspection result normal?

>> Replace harness connectors.

Check the wiring harness externals.

Is the inspection result normal?

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

(Trouble diagnosis content)

CONTROL UNIT
(airbag control unit internal trouble, EE-
PROM)

Air bag diagnosis sensor unit is malfunctioning

CONTROL UNIT
(airbag control unit internal trouble, Algorithm)

CONTROL UNIT
(airbag control unit internal trouble, Configu-
ration)

CONTROL UNIT
(airbag control unit internal trouble, other
component)

CONTROL UNIT
(airbag control unit internal trouble, other)

B1416, B1417, B1418, B1419, B1420 AIR BAG DIAGNOSIS SENSOR UNIT

Replace air bag diagnosis sensor unit. Refer to

B1421 FRONTAL COLLISION DETECTION

Источник

Оцените статью
Adblock
detector