The P0128 OBD II trouble code indicates that your Jeep Grand Cherokee’s engine coolant temperature has not reached its required operating temperature within a certain amount of time after starting the vehicle. This code can appear as soon as you start your vehicle, or it can also occur while driving.
It’s essential to address this issue immediately, as vehicles with this issue have increased emissions and decreased fuel efficiency. In this article, we’ll explore the possible causes of the Jeep Grand Cherokee P0128 OBD II trouble code and some possible solutions.
P0128 is most often caused by a thermostat that is stuck open.
Definition | P0128: Coolant Temperature – Below Thermostat Regulating Temp |
Symptoms | Lack of heat, MIL (check engine light), MPG Loss (1 or 2 tops) |
Common Causes | Thermostat stuck open, Engine Coolant Temp Sensor (ECT) issues |
Breakdown Risk? | No |
Repair Cost (Parts) | Less than $100 |
Repair Difficulty | Moderate |
The P0128 OBD-II trouble code is a generic powertrain diagnostic code (it has the same meaning for the Jeep Grand Cherokee as any other vehicle).
The coolant temp sensor is responsible for telling the Engine Control Module (ECM) the engine’s coolant temperature.
P0128 indicates an issue with the engine’s coolant temperature not reaching the proper operating temperature within a certain amount of time.
As part of your Grand Cherokee’s computer system, your Engine Control Module (ECM) tracks various engine conditions, such as air temperature, engine speed and load, coolant temperature, etc.
When the ECM detects that the engine’s coolant is not reaching its proper operating temperature within a set timeframe, it will trigger this P0128 trouble code to alert the driver of a potential issue.
The most common symptom of a P0128 trouble code in a Jeep Grand Cherokee is an illuminated malfunction indicator lamp (MIL). Other symptoms may include poor engine performance and a decrease in fuel economy.
Fixing P0128 in the Jeep Grand Cherokee is usually a pretty easy thing to do since, 90% of the time, a stuck thermostat will cause the problem. Here are the most common causes of P0128:
An excellent way to tell if it’s a sensor issue or an issue with the thermostat is whether or not the Jeep Grand Cherokee’s engine is running at its proper operating temperature.
It can be challenging to tell this in a vehicle that doesn’t have a temperature gauge. If you feel the heater isn’t working well, that is the easiest way to tell the thermostat is stuck open.
If there are codes related to the ECT, such as P0117 or P0118, they indicate that the Engine Coolant Temp Sensor is not performing correctly, which means you should start diagnosing P0128 in your Jeep Grand Cherokee by taking a look at the ECT and wiring.
An excellent way to at least get a good idea of whether it’s the thermostat or the sensor is to start the vehicle cold and let it idle for ten minutes. If you feel little to no heat from the heater, it’s a good indication that the thermostat is the problem and not a wiring issue.
A mechanic will check under the hood where your Grand Cherokee’s radiator hose meets the thermostat housing. If it is easy to pinch the hose, the engine coolant will typically flow through it.
If you pinch your hose, stay aware of the belted accessories and the fan. The fan can come on at any time .
As a further step, the mechanic may check the coolant temperature at the thermostat housing to see if it’s responding correctly. If it isn’t, there’s likely an issue with the thermostat itself.
You’ll need an infrared temperature gun to verify the temperature at the thermostat. They’re not very expensive at places such as Harbor Freight.
The mechanic will also inspect all electrical connections to ensure they are in good condition and not corroded or loose. If they are, repair the harness and verify that it clears the code.
If all of the above checks out and it still seems like the thermostat is the culprit, then it’s time to replace it. Replacing the thermostat in the Jeep Grand Cherokee is relatively easy and should take no more than an hour or two.
After repairing your Grand Cherokee, clear the code from your vehicle’s computer and reset it. Then, take a test drive and verify that it hasn’t returned.
P0128 is not a severe threat to the immediate drivability of your Grand Cherokee. However, it should be noted that most modern fuel-injected engines like to run at 200+ degrees. Letting them run too cool can cause problems after an extended period. Good luck figuring out what is going on with your Grand Cherokee!
RECALLS! January 2022 Jason, “MAZDA6 shuts down while driving” fuel pump not monitored, may be no engine light etc. SEE…
I have a 2007 h3 hummer base model. Had transmission rebuilt (Pro).My problem is that when it gets around 35…
deonisy
прогревшись движок не развивает мощности не поднимаются обороты выше 2800 и не едет больше 130 мигает неисправность дроссельной заслонки и горит чек неисправности двигателя ,хотя на холодную все ок . в чем проблема что можно сделать своими руками диллер далеко .может что то снять почистить .помогите кто может![veteran32200@mail.ru]Пишите мне[/email]
vasilich
foedus
vasilich
Van777
Вариантов много, конечно нужен сканер, считать ошибку! Может быть что угодно, и поломка Swirl ( привод управления заслонками, больное место, попадает масло под патрубком турбины), и просто нарушение работы клапана EGR ( сам чистил), и просто выход из строя форсунки или одного из датчиков. Двигатель, как я понял, переходит в аварийный режим. Нужен код ошибки!
Нет предела совершенству!
Продай Родину, купи Джип!
deonisy
3.0 CRD : у меня вообще не понятная история день ото дня молния гаснет и все работает ок только чек горит всегда . пробовал чистил клапан ERG все так же . сегодня снимал моторчик привода заслонок распечатал днище слил масло которое похоже натикло с турбины визуально все работоспособное . промыл все бензином внутри и с наружи .поставил дополнительный маслоотделитель . собрал завел чек горит но молния потухла движок работает ок . но вот не задача проехав км 15 все нормально заглушил . часа через два поехал началась таже самая история загорелась молния пропала мощность . уже не знаю что делать может какой то датчик моросит . помогите кто нибудь .
Van777
Без кода, наугад, делать выводы сложно. У меня тоже загоралась молния и двигатель переходил в аварийный режим, ток чек не горел, заглушу двигатель, скину клемму с аккума, и все в норме поехал дальше. Подключили сканер и вердикт — ошибка на клапане EGR, нужно чистить, если не поможет — клапан под замену. А ведь в этой завязке и привода заслонок, и сами заслонки, кстати бывают закоксовываются, наверное от нашего топлива.
Нет предела совершенству!
Продай Родину, купи Джип!
vovan
deonisy
Без кода, наугад, делать выводы сложно. У меня тоже загоралась молния и двигатель переходил в аварийный режим, ток чек не горел, заглушу двигатель, скину клемму с аккума, и все в норме поехал дальше. Подключили сканер и вердикт — ошибка на клапане EGR, нужно чистить, если не поможет — клапан под замену. А ведь в этой завязке и привода заслонок, и сами заслонки, кстати бывают закоксовываются, наверное от нашего топлива.
да клапан почти чистый был но все равно промыл сейчас даже слышно как хлопает я не думаю что заслонки за коксовались моторчик привода снимал тяги нормально легко ходят.
Guest_almazzz70_*
Guest_almazzz70_*
прогревшись движок не развивает мощности не поднимаются обороты выше 2800 и не едет больше 130 мигает неисправность дроссельной заслонки и горит чек неисправности двигателя ,хотя на холодную все ок . в чем проблема что можно сделать своими руками диллер далеко .может что то снять почистить .помогите кто может![veteran32200@mail.ru]Пишите мне[/email]
У меня точно такое было. Только замена заслонки. Находиться далеко(крутил в руках старую-всё запаяно ), машину мастеру оставлял на 4 часа. На итерховмане покупал , на «энергии» дороже-Это мэрсовские станции.Покупайте к мотору заслонки пластмассовые защёлки, старые при замене ломаются их брал в Энергии.
deonisy
[quote name=’almazzz70′ timestamp=’1307560008′ post=’11049′]
У меня точно такое было. Только замена заслонки. Находиться далеко(крутил в руках старую-всё запаяно ), машину мастеру оставлял на 4 часа. На итерховмане покупал , на «энергии» дороже-Это мэрсовские станции.Покупайте к мотору заслонки пластмассовые защёлки, старые при замене ломаются их брал в Энергии.
Александр Шахлевич
а многие вот так выходят из проблемы с помощью резистора на 4.7кОм
радикал фото
Взято с дружественного российского форума http://jeep4x4club.r. k-na-30-crd/там 13 страниц как выйти из этой проблемы, рекомендую
Сообщение изменено: Александр Шахлевич (27 Май 2014 — 09:18 )
kayot88
ребята здрасте, такая же проблема, сегодня сбил ошибки на сканере все прошло, но началась новая проблема стала глохнуть на холостом ходу и на драйве когда стоишь, а особенно когда включена клима что это может быть? и подскажите пожалуйста хороши сервис по ремонту, или кто может посмотреть буду очень благодарен
Сообщение изменено: kayot88 (05 Август 2014 — 10:16 )
Adblock