Nissan Murano. Manual — part 411
If some DTCs are displayed at the same time, perform inspections one by one based on the following priority
chart.
INFOID:0000000009719127
• 1 — 39: Displayed if any previous malfunction is present when current condition is normal. It increases like 1
39 after returning to the normal condition whenever ignition switch OFF
remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch
OFF
ON after returning to the normal condition if the malfunction is detected again.
Display contents of CONSULT
Intermittent clutch function
Intermittent clutch function
All following condition are satisfied
• Power supply condition of auto-
matic back door control unit: OFF
• BCM receive ignition position sig-
Inhibit automatic back door operation
When receiving the pulse from en-
coders A and B normally (5 pulses)
Intermittent clutch function
Half latch switch is ON from OFF
During close operation: Intermittent clutch
function
During close operation: Intermittent clutch
function
Inhibit automatic back door operation
Reception of next operation request
Inhibit automatic back door operation
Erase DTC, reconnect battery
Inhibit automatic back door operation
Erase DTC, reconnect battery
Intermittent clutch function
Reception of next operation request
Intermittent clutch function
Detect back door fully closed posi-
tion
Intermittent clutch function
Reception of next operation request
Inhibit automatic back door operation
Normal return or reconnect battery
• U1000: CAN COMM CIRCUIT
• U1010: CONTROL UNIT (CAN)
• B2401 IGN OPEN
• B2403 PULSE ENCODER
• B2409 HALF LATCH SW
• B2416 TOUCH SEN R OPEN
• B2417 TOUCH SEN L OPEN
• B2418 CLUTCH PWR SPLY
• B2419 OPEN SW
• B2420 CLOSE SW
• B2421 CLUTCH TIME OUT
• B2422 BACK DOOR STATE
• B2423 ABD MTR TIME OUT
• B2424 CLSR CONDITION